LARGE OLD PUNCH Press. I'm not sure of the tonnage but suspect it's in the 20-40 ton range. This is an old machine that has been in use in our shop for years and given great service. Shut height is about 9.75 inches. 230 Volt 3-phase. If you're looking to do some production punching, stamping, or forming, this one would be a great buy because: 1. it works; 2. it's very inexpensive. For the one-man shop looking to increase production/ capability, this might be just the ticket. This is a foot pedal operated machine; you will not be able to use it in an OSHA type shop without major modification. We had it hooked up to operate with two pneumatic push buttons but it has been returned to its original foot pedal configuration. I can supply a few parts to get you headed in the right direction if you decide to go back to the 2-button operation. This is a big machine, probably weighs around 3500-4000 pounds with the fly wheel attached (which is removeable for transport). Machine measures approximately 36" wide x 57" deep x 86" high. Don't let the looks fool you, there's still a lot of use left in this one. We can remove the fly wheel and put it on a pallet and load your trailer with both the machine and flywheel. We're happy to run it for a serious potential buyer and would prefer that you were present when we remove the fly wheel shield and fly wheel so you can see how it all goes back together. This one is too big to put in the back of a pickup truck. $500, online pic at nickelsworth.com. 208-660-5135, twilkin@frontier.com, Post Falls, ID